How to remove the underside of the laminated particle board?

It can be said that laminated particle board is used in many of our lives, especially at home. However, when you want to decorate or renovate your home, how do you make the laminated particle board not interfere with your decoration? So I will tell you some information about the removal of laminated particle board.

table of Contents

• Reason for removing the underside of the laminated particle board

• Step of removing the underside of the laminated particle board

• summary

Reason for removing the underside of the laminated particle board

The laminated particle board is an engineered composite wood product made of wood chips, sawmill shavings and wood chips bonded together with synthetic resin, which is then pressed and extruded. The laminated particle board is a popular alternative to traditional wood and plywood because it is denser, more uniform, and less expensive. It is often used as a primer for continuous vinyl floor coverings because it can swell and discolor when exposed to moisture.

If you are considering replacing your current tiles with something different, you will need to remove any pre-existing negatives, as not all materials will be compatible with the type of tile you are planning to use. The bottom layer is a layer of material between the sub-layer and the finished floor covering in your home and is used for a variety of reasons, providing a surface glue and mortar that is easy to bond without damaging the bottom layer, raising the ground, and strengthening the bottom layer And the framework system. Removing the underside is a daunting task because the bottom of the particleboard is usually nailed and glued to the ground. However, this is possible, and you can save a lot of money by yourself!

Step of removing the underside of the laminated particle board

The first step - getting ready for yourself and the room

Since cutting the laminated particle board releases a lot of wood chips that can irritate the eyes and the respiratory system, it is necessary to wear safety goggles and a dust mask. Since you will have a lot of nails, nails and screws on your knees on your knees, a knee pad is also a must. Use leather gloves to protect your hands from the saw. Remove all furniture from the room before starting to remove the base. Remove any substrate at the same time and trim with a mast.

The second step - Cutting the base

If you stick the film to the floor, if you just want to pull it down, it is impossible to remove it without damaging the floor. To reduce the likelihood of this happening, use a circular saw to cut the particleboard into 2x2 feet of debris.

The third step - pick up the base

Insert the superb flat end into the edge of the saw and start picking it up from the floor. Do this on the edge around you until you can put the iron under the base of the mast.

The forth step - Loosen the fasteners

Work with the iron rod around the edge of the part before picking up the middle part. Since the particle board is relatively weak, it is possible for the fastener to pass through the chassis and remain on the floor.

The fifth step - Remove fasteners and mortars

Use a super rod to remove the fasteners on the floor. Use a scraper to gently remove any stucco from the ground. Dispose of all waste immediately to avoid debris or more serious damage from sharp nails.

summary

If you need a laminated board or Laminated MDF in your renovation, you can also contact us. Our ingredients are the best and won't let you down.